Dây Hút Thiếc FR100-03 Hakko

Dây Hút Thiếc FR100-03

HAKKO WICK
	Faster thermal transmission for superior performance at lower temperature and with lower wattage soldering irons.
	Three different · Regular type : Rosin flux treated copper braid · Unflux type : Untreated copper braid · No clean type : Low residue flux treated copper braid                         Using ESD SAFE package

Removal for thru-hole...

Removal for bridging...

Desoldering wire is used to remove solder from an elemental device or from patterns on a printed circuit board (PCB) from which surface-mounted devices such as BGA (ball grid array) have been removed.

Trick to remove solder well with the desoldering wire

Wrong use of the desoldering wire may tear patterns from a PCB or damage discrete components. In order to prevent these problems, make sure to take the preventive measure below: Apply a bit of solder to the tip of solder iron. Apply a bit of solder to the tip of the desoldering wire. Cut the soldered tip of the wire at an angle of 45 degrees. Solder should remain attached. Preliminary soldering improves heat conductance. Click here for details.

How to use HAKKO WICK (Movie: 444KB)

Put the desoldering wire onto the soldering part. Press the desoldering wire with the soldering iron on the wire After melted with the heat of the soldering tip, the solder is sucked up into the desoldering wire Be careful not to press the soldering tip down for too long. Otherwise, the pattern will come off. Remove the desoldering wire and soldering iron at the same time.

Regular type -Flux-

Part No.	Name/Description
FR100-00	HAKKO WICK <REGULAR> 1.5MX0.6MM
FR100-01	HAKKO WICK <REGULAR> 1.5MX0.9MM
FR100-02	HAKKO WICK <REGULAR> 1.5MX1.4MM
FR100-03	HAKKO WICK <REGULAR> 1.5MX1.9MM
FR100-04	HAKKO WICK <REGULAR> 1.5MX2.5MM
FR100-05	HAKKO WICK <REGULAR> 1.5MX3.3MM

Ý kiến người dùng

Chưa có ý kiến

Tài Khoản	Khách Vãng Lai
Địa chỉ Email
Đánh Giá
Mã xác nhận:  (Kích chuột vào mã nếu bạn muốn đổi)
Nhận Xét

Mua sản phẩm khác

Mỡ Hàn ZJ-18 80G

Hộp Đựng Nước Rửa Mạch 10...

Bọt Biển Tròn 5CM

Máy Khoan Mạch M665

Búi Đồng Làm Sạch Thiếc

Máy Hàn KS-936

Bọt Biển 6x6CM Dầy 5MM

Mỡ Hàn ZJ-18 150g

Kẹp Nhựa 93303 KN03

Jump Đôi Đực 2.54MM 2x40P...